Home › BRAKE › BRAKE CONTROL › SKID CONTROL BUZZER

SKID CONTROL BUZZER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)



2. REMOVE FRONT DOOR SCUFF PLATE


    B173224
  1. Disengage the 8 claws and guide, and remove the front door scuff plate LH.



3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY


    B173227
  1. Remove the clip.

  1. Disengage the clip and claw, and remove the cowl side trim sub-assembly LH.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)


    B168371
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 claws and 10 clips.

  1. Disconnect each connector.

  1. Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)


    B173021
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 claws and 10 clips.



    B173009
  1. Disconnect each connector and the aspirator duct.

  1. Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



6. REMOVE SKID CONTROL BUZZER


    C165816
  1. Disconnect the skid control buzzer connector.



    C165826E01
  1. Remove the clamp and the skid control buzzer.