FRONT DOOR BELT MOULDING > INSTALLATION |
| 1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY |
![]() |
Engage the 6 claws and install the front door belt moulding assembly.
| 2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY |
Apply MP grease to the sliding parts of the front door window regulator sub-assembly.
![]() |
Install the temporary bolt to the front door window regulator sub-assembly.
Temporarily install the window regulator.
Tighten the 6 bolts in the order shown in the illustration to install the front window regulator.
| 3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY |
![]() |
Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated in the order of the arrows in the illustration.
![]() |
Install the front door glass sub-assembly with the 2 bolts.
![]() |
Install the hole plug.
| 4. INSTALL FRONT DOOR SERVICE HOLE COVER |
Apply butyl tape to the front door panel.
Pass the front door lock remote control cable and rear door inside the locking cable through a new front door service hole cover.
![]() |
Attach the front door service hole cover according to the reference points on the front door panel.
![]() |
Connect each connector.
Engage the 2 clamps.
| 5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER |
![]() |
Engage the claw, and temporarily install the outer rear view mirror assembly with cover.
Tighten the 3 nuts in the order shown in the illustration to install the outer rear view mirror assembly with cover.
![]() |
Engage the clamp and connect the connector.
Install the clip.
| 6. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Install the front No. 1 speaker assembly with the 4 bolts.
Connect the connector.
| 7. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP |
![]() |
Install the front door inner glass weatherstrip.
| 8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
Connect the connector.
![]() |
Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.
Engage the 2 clamps.
![]() |
Engage the front door trim board with the 5 claws on the front door inner glass weatherstrip.
Engage the 9 clips.
![]() |
Install the 2 screws <B>.
Install the screw <A> and front door trim board to the front door panel.
| 9. INSTALL COURTESY LIGHT ASSEMBLY |
Connect the connector.
![]() |
Engage the claw and install the courtesy light assembly.
| 10. INSTALL ASSIST GRIP COVER |
![]() |
Engage the 4 claws and install the assist grip cover.
| 11. INSTALL FRONT ARMREST UPPER BASE PANEL |
Connect the connector.
![]() |
Engage the 7 claws and clip and install the front armrest upper base panel.
| 12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG |
![]() |
Engage the 3 claws and install the front door inside handle bezel plug.
| 13. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH |
![]() |
Engage the clip and claw, and install the front door lower frame bracket garnish.
| 14. CONNECT NEGATIVE BATTERY TERMINAL |
| 15. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Driver Side) |