REAR DOOR BELT MOULDING > INSTALLATION |
| 1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY |
![]() |
Engage the 6 claws and install the rear door belt moulding assembly.
| 2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY |
Apply MP grease to the sliding parts of the rear door window regulator sub-assembly.
![]() |
Install the temporary bolt to the rear door window regulator sub-assembly.
Temporarily install the window regulator.
Tighten the 4 bolts in the order shown in the illustration to install the rear door window regulator.
Connect the connector.
| 3. INSTALL REAR DOOR GLASS RUN |
![]() |
Install the rear door glass run.
| 4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
Slide the rear door glass sub-assembly to install it as shown in the illustration.
| 5. INSTALL REAR DOOR QUARTER WINDOW GLASS |
Install the rear door quarter window glass to the rear door quarter window weatherstrip.
![]() |
Install the rear door quarter window glass together with the rear door quarter window weatherstrip in the direction indicated by the arrow in the illustration.
| 6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
Insert the rear door window division bar sub-assembly from above.
Install the rear door glass run to the rear door lower window frame sub-assembly.
![]() |
Install the rear door window division bar sub-assembly with the 2 bolts and screw.
![]() |
Install the rear door vent seal.
| 7. INSTALL REAR DOOR SERVICE HOLE COVER |
Apply butyl tape to the rear door panel.
![]() |
Pass the rear door lock remote control cable, rear door inside locking cable and each connector through a new rear door service hole cover.
Attach the rear door service hole cover according to the reference points on the rear door panel.
Connect the connector.
| 8. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP |
![]() |
Install the rear door inner glass weatherstrip.
| 9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the rear door lock remote control cable and rear door inside locking cable to the rear door inside handle sub-assembly.
Engage the 2 clamps.
![]() |
Engage the rear door trim board with the 5 claws on the rear door inner glass weatherstrip.
Engage the 9 clips and install the rear door trim board to the rear door panel.
![]() |
Install the 2 screws <B>.
Install the screw <A>.
| 10. INSTALL DOOR ASSIST GRIP COVER |
![]() |
Engage the 4 claws and install the door assist grip cover.
| 11. INSTALL REAR DOOR ARMREST UPPER BASE PANEL |
Connect the connector.
![]() |
Engage the 6 claws and 2 clips and install the rear door armrest upper base panel.
| 12. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG |
![]() |
Engage the 3 claws to install the rear door inside handle bezel plug.
| 13. CONNECT NEGATIVE BATTERY TERMINAL |