Home › BRAKE › BRAKE CONTROL › BRAKE PEDAL LOAD SENSING SWITCH

BRAKE PEDAL LOAD SENSING SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH

NOTICE:
  1. Do not remove the brake pedal load sensing switch from the brake pedal support.
  2. When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support.

  1. Turn the ignition switch off.

  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.



  1. Disconnect the brake pedal load sensing switch connector.


    C168971E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (FSW+) - 1 (GND)
    Brake pedal load sensing switch OFF (Brake pedal depressed)
    950 to 1050 Ω
    2 (FSW+) - 1 (GND)
    Brake pedal load sensing switch ON (Brake pedal released)
    203 to 223 Ω

    If the value is not as specified, replace the brake pedal support assembly (Click here).