HEADLIGHT DIMMER SWITCH > INSTALLATION |
| 1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY |
![]() |
Engage the claw while loosening the clamp as shown in the illustration.
![]() |
Engage the clamp and install the headlight dimmer switch assembly as shown in the illustration.
Connect the connector.
| 2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY |
![]() |
Engage the claw and install the windshield wiper switch assembly.
Connect the 2 connectors.
| 3. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() |
Install the spiral cable with steering angle sensor with the 3 claws.
Connect the connectors to the spiral cable with steering angle sensor.
| 4. INSTALL STEERING COLUMN COVER |
![]() |
Engage the claw to install the upper steering column cover.
![]() |
Engage the 2 claws to install the lower steering column cover.
![]() |
Install the 2 screws.
| 5. POSITION FRONT WHEELS STRAIGHT AHEAD |
| 6. ADJUST SPIRAL CABLE SUB-ASSEMBLY |
Check that the ignition switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Rotate the spiral cable counterclockwise slowly by hand until it stops.
![]() |
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
| 7. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks on the steering wheel assembly and steering main shaft.
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly.
| 8. INSPECT STEERING WHEEL CENTER POINT |
| 9. INSTALL STEERING PAD |
Check that the ignition switch is off.
Check that the battery negative (-) terminal is disconnected.
![]() |
Support the steering pad with one hand as shown in the illustration.
![]() |
Connect the 2 airbag connectors to the steering pad.
Connect the horn connector to the steering pad.
Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
![]() |
Using a "TORX" socket wrench (T30), tighten the 2 "TORX" screws.
| 10. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Install the lower No. 2 steering wheel cover with the claw.
| 11. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Install the lower No. 3 steering wheel cover with the claw.
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. INSPECT STEERING PAD |
![]() |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Make sure that the horn sounds.
| 14. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).