SPIRAL CABLE > REMOVAL |
| 1. PRECAUTION |
| 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Disengage the claw and remove the lower No. 3 steering wheel cover.
| 5. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
Disengage the claw and remove the lower No. 2 steering wheel cover.
| 6. REMOVE STEERING PAD |
![]() |
Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
![]() |
Disconnect the horn connector from the steering pad.
Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.
| 7. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the steering main shaft.
Disconnect the connectors from the spiral cable.
![]() |
Using SST, remove the steering wheel assembly.
| 8. REMOVE STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
![]() |
Disengage the 2 claws to remove the lower steering column cover.
![]() |
Disengage the claw to remove the upper steering column cover.
| 9. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR |
![]() |
Disconnect the connectors from the spiral cable with steering angle sensor.
Disengage the 3 claws and remove the spiral cable with steering angle sensor.
| 10. REMOVE SPIRAL CABLE |
![]() |
Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.