Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    C165090
  1. Disengage the claw and remove the lower No. 3 steering wheel cover.



3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    C165091
  1. Disengage the claw and remove the lower No. 2 steering wheel cover.



4. REMOVE STEERING PAD


    C166981E01
  1. Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.



    C165092
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    C165094E01
  1. Disconnect the horn connector from the steering pad.

  1. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



5. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Microphone)


    E150585
  1. Disconnect the steering pad switch connector from the spiral cable.

  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch.



    E150586
  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch assembly.



6. REMOVE STEERING PAD SWITCH LH (w/o Microphone)


    E173905
  1. Disconnect the steering pad switch connector from the spiral cable.

  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch LH.