Home › HYBRID SYSTEM ยท P310 › HYBRID TRANSMISSION / TRANSAXLE › HYBRID VEHICLE TRANSAXLE

HYBRID VEHICLE TRANSAXLE > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH HYBRID VEHICLE TRANSAXLE
(Click here)


2. REMOVE MANIFOLD STAY


    A176007
  1. Remove the bolt, nut, and the manifold stay.



3. REMOVE HYBRID TRANSAXLE MASS DAMPER


    A109817
  1. Remove the bolt and transaxle mass damper.



4. REMOVE REAR ENGINE MOUNTING INSULATOR


    A175947
  1. Remove the 3 bolts and rear engine mounting insulator.



5. REMOVE FRONT FRAME ASSEMBLY


    A108133
  1. Remove the nut and separate the front engine mounting insulator.



    A078403E07
  1. Remove the 2 nuts and separate the engine mounting insulators RH and LH.



6. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


    C165535E01
  1. Using SST, remove the front drive shaft assembly LH.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    1. Be careful not to damage the drive shaft dust cover, boot, or oil seal.
    2. Be careful not to drop the drive shaft assembly.



7. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH


    C167529
  1. Remove the bearing bracket hole snap ring from the drive shaft bearing bracket.

  1. Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.

    NOTICE:
    Do not damage the boot or oil seal.



8. REMOVE FLYWHEEL HOUSING UNDER COVER


    C105748
  1. Remove the 2 bolts and flywheel housing under cover.



9. SEPARATE ENGINE WIRE
  1. Remove the bolt and ground wire.

  1. Disconnect the wire harnesses from the brackets.



  1. Disconnect the connectors.


    C172747



    C172748
  1. Remove the 2 bolts and transmission case cover from the hybrid vehicle transaxle.



    C172749
  1. Remove the 7 bolts and 7 brackets.



10. REMOVE AUTOMATIC TRANSMISSION CASE COVER


    C172750
  1. Remove the bolt and transmission control cable bracket.

  1. Remove the bolt, clip and transmission case cover from the hybrid vehicle transaxle.



11. REMOVE WATER HOSE


    C105797
  1. Disconnect the water hose from the hybrid vehicle transaxle.



12. REMOVE FRONT ENGINE MOUNTING BRACKET


    C105752
  1. Remove the 3 bolts and engine mounting bracket.



13. REMOVE OIL COOLER TUBE SUB-ASSEMBLY


    C173270
  1. Remove the bolt and tube support bracket.



    C173269
  1. Using union nut wrench 17 mm and a wrench, disconnect the 2 oil cooler tubes.



    C172977
  1. Remove the bolt and clamp.



14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
  1. Remove the 2 bolts and No. 1 transmission control cable bracket.



15. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY


    C177943
  1. Remove the 8 bolts.

  1. Separate and remove the hybrid vehicle transaxle.

    NOTICE:
    Do not pry out the connection between the transaxle assembly and engine more than necessary to prevent the knock pin from being damaged.