Home › HYBRID SYSTEM ยท Q211 HYBRID TRANSMISSION / TRANSAXLE › DUST COVER

DUST COVER > REMOVAL

for Preparation Click here



1. DRAIN HYBRID TRANSAXLE FLUID


    C170282E01
  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.

  1. Using a socket hexagon wrench 10 mm, install the drain plug and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



2. REMOVE REAR WHEEL


3. REMOVE EXHAUST PIPE ASSEMBLY (for RH Side)
(Click here)


4. REMOVE REAR AXLE SHAFT NUT


    C165539E01
  1. Using SST and a hammer, release the staked part of the rear axle shaft nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

  1. While applying the brakes, remove the rear axle shaft nut.



5. SEPARATE REAR STRUT ROD ASSEMBLY


    C105707
  1. Support the rear axle carrier with a wooden block placed between the jack and axle carrier.



    C105708
  1. Remove the bolt, nut and rear strut rod assembly.

    NOTICE:
    Hold the nut to turn the bolt.



6. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY


    C105709
  1. Remove the bolt and nut, and separate the rear No. 1 suspension arm assembly LH.

    NOTICE:
    Hold the nut to turn the bolt.



7. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    C105710
  1. Remove the bolt and nut, and separate the rear No. 2 suspension arm assembly LH.

    NOTICE:
    Hold the nut to turn the bolt.



8. REMOVE REAR DRIVE SHAFT ASSEMBLY


    C108295E02
  1. Put matchmarks on the rear drive shaft assembly and differential side gear shaft.

  1. Remove the 4 nuts, washers and rear drive shaft assembly.



9. REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY


    C170283E01
  1. Using SST, remove the side gear shaft.

    SST
    09520-24010   (09520-04010, 09520-32040)

    NOTICE:
    Do not damage the oil seal.



    C067703
  1. Using 2 screwdrivers and a hammer, remove the side gear shaft snap ring.



10. REMOVE DUST COVER


    C022306
  1. Clamp the side gear shaft in a vise.

    NOTICE:
    Do not damage the side gear shaft.

  1. Using a screwdriver and a hammer, remove the dust cover.