HYBRID TRANSAXLE SIDE GEAR OIL SEAL > REMOVAL |
| 1. DRAIN HYBRID TRANSAXLE FLUID |
![]() |
Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.
Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.
Using a socket hexagon wrench 10 mm, install the drain plug and a new gasket.
| 2. REMOVE REAR WHEEL |
| 3. REMOVE EXHAUST PIPE ASSEMBLY (for RH Side) |
| 4. REMOVE REAR AXLE SHAFT NUT |
![]() |
Using SST and a hammer, release the staked part of the rear axle shaft nut.
While applying the brakes, remove the rear axle shaft nut.
| 5. SEPARATE REAR STRUT ROD ASSEMBLY |
![]() |
Support the rear axle carrier with a wooden block placed between the jack and axle carrier.
![]() |
Remove the bolt, nut and rear strut rod assembly.
| 6. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY |
![]() |
Remove the bolt and nut, and separate the rear No. 1 suspension arm assembly LH.
| 7. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY |
![]() |
Remove the bolt and nut, and separate the rear No. 2 suspension arm assembly LH.
| 8. REMOVE REAR DRIVE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the rear drive shaft assembly and differential side gear shaft.
Remove the 4 nuts, washers and rear drive shaft assembly.
| 9. REMOVE DIFFERENTIAL SIDE GEAR SHAFT SUB-ASSEMBLY |
![]() |
Using SST, remove the side gear shaft.
![]() |
Using 2 screwdrivers and a hammer, remove the side gear shaft snap ring.
| 10. REMOVE REAR TRANSAXLE SIDE GEAR OIL SEAL |
LH side:
![]() |
Using SST, remove the oil seal.
RH side:
![]() |
Using SST, remove the oil seal.