Home › HYBRID SYSTEM ยท P310 › HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE FLUID

HYBRID TRANSAXLE FLUID > REPLACEMENT

for Preparation Click here



1. DRAIN HYBRID TRANSAXLE FLUID


    C173143E01
  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.

  1. Using a socket hexagon wrench 10 mm, install the drain plug, and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



2. ADD AND INSPECT HYBRID TRANSAXLE FLUID
  1. Add transaxle fluid.



    C173144E01
  1. Check that the fluid surface is within 5 mm (0.20 in.) from the lowest position of the inner surface of the differential filler plug opening.

    NOTICE:
    1. Keep the fluid temperature at 5°C (41°F) or higher.
    2. Stop the vehicle on a flat road.
    3. Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.

  1. Using a socket hexagon wrench 10 mm, temporarily tighten the filler plug and gasket.

  1. Enter 2WD inspection mode (Click here).

  1. After waiting for 1 minute or more, stop the engine.

  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Add transaxle fluid.



    C173144E01
  1. Check that the fluid surface is within 5 mm (0.20 in.) from the lowest position of the inner surface of the differential filler plug opening.

    NOTICE:
    1. Keep the fluid temperature at 5°C (41°F) or higher.
    2. Stop the vehicle on a flat road.
    3. Recheck the transaxle fluid level after driving when exchanging fluid.
    4. Insufficient or excessive amounts of transaxle fluid may be the cause of some trouble.

  1. Check for leaks if the fluid level is low.

  1. Using a socket hexagon wrench 10 mm, install the filler plug, and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }