FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FOR FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK |
Check fuel pump operation.
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and push the Techstream main switch on.
Select the following menu items: Power train / Engine / Active Test / Control the Fuel Pump Speed.
Check for pressure in the fuel inlet tube from the fuel line. Check that sound of fuel flowing in the fuel tank can be heard. If no sound can be heard, check the integration relay, fuel pump, hybrid vehicle control ECU and wiring connector.
Check that there are no fuel leaks anywhere on the fuel system after performing maintenance.
Inspect for fuel leaks.
Check that there are no fuel leaks anywhere on the system after performing maintenance. If there is a fuel leak, repair or replace parts as necessary.
Turn the power switch off.
Disconnect the Techstream from the DLC3.
| 2. CHECK FUEL PRESSURE |
Discharge fuel system pressure (Click here).
Using a voltmeter, measure the battery voltage.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the fuel hose from the fuel main tube (Click here).
Install SST (pressure gauge and fuel tube connector) as shown in the illustration.

Wipe up any gasoline.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and push the Techstream main switch on.
Select the following menu items: Power train / Engine / Active Test / Control the Fuel Pump Speed.
Measure the fuel pressure.
Disconnect the Techstream from the DLC3.
Put the vehicle in the "inspection mode". (Click here)
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine stops.
After checking the fuel pressure, carefully disconnect the cable from the negative (-) battery terminal, and remove SST and fuel tube connector to prevent gasoline from splashing.
Reconnect the fuel tube to the main fuel tube (fuel tube connector).
Install the No. 1 fuel pipe clamp to the fuel tube connector.
Inspect for fuel leaks (step 1).