Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the engine immobiliser system.
  1. The Techstream should be used in steps 5 and 7.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      HINT:
      1. When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CRANK ENGINE FOR MORE THAN 10 SECONDS

      NEXT


      5.CHECK FOR DTCS
      1. Check for DTCs and note any codes that are output (Click here).

      2. Delete the DTCs.

      3. Recheck for DTCs. Based on the DTCs output above, try to duplicate the hybrid system DTC, engine immobiliser system DTC, steering lock system DTC, or smart key system (starting) DTC by simulating the symptoms indicated by the DTCs.

        Result:

        Result
        Proceed to
        Hybrid system DTC output recurs
        A
        (Click here)
        Engine immobiliser system DTC output recurs
        B
        (Click here)
        Steering lock system DTC output recurs
        C
        (Click here)
        Smart key system (starting) DTC output recurs
        D
        (Click here)
        DTC output does not recur
        E



      A.
      GO TO HYBRID CONTROL SYSTEM (DTC CHART)

      B.
      GO TO ENGINE IMMOBILISER SYSTEM (DTC CHART)

      C.
      GO TO STEERING LOCK SYSTEM (DTC CHART)

      D.
      GO TO SMART KEY SYSTEM (STARTING) (DTC CHART)
      E


      6.PROBLEM SYMPTOMS TABLE

        Result:

        Result
        Proceed to
        Fault is listed in problem symptoms table
        A
        Fault is not listed in problem symptoms table
        B



      A.
      GO TO STEP 8
      B


      7.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. DATA LIST/ACTIVE TEST (Click here)

      2. TERMINALS OF ECU (Click here)


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END