Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P2610    ECM / PCM Internal Engine Off Timer Performance

for Preparation Click here


DTC SUMMARY


DTC No.
Monitoring Item
DTC Detection Condition
Trouble Area
Detection Timing
Detection Logic
P2610
Soak timer (built into ECM (Included in hybrid vehicle control ECU))
ECM (Included in hybrid vehicle control ECU) internal malfunction
Hybrid vehicle control ECU
Engine running
2 trips

DESCRIPTION

To ensure the accuracy of the EVAP (Evaporative Emission) monitor values, the soak timer, which is built into the ECM (included in the hybrid vehicle control ECU), measures 5 hours (+/- 15 minutes) from the time the power switch is turned off, before the monitor begins to run. This allows the fuel to cool down, which stabilizes the Fuel Tank Pressure (FTP). When 5 hours have elapsed, the ECM turns on.

MONITOR DESCRIPTION

5 hours after the power switch is turned off, the soak timer activates the ECM (included in the hybrid vehicle control ECU) to begin the EVAP system monitor. While the engine is running, the ECM monitors the synchronization of the soak timer and the CPU clock. If these two are not synchronized, the ECM interprets this as a malfunction. The ECM illuminates the MIL and sets the DTC (2 trip detection logic).

MONITOR STRATEGY


Required Sensors/Components
ECM (included in the hybrid vehicle control ECU)
Frequency of Operation
Once per driving cycle
Duration
600 seconds
MIL Operation
2 driving cycles
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


All: 
Monitor runs whenever following DTCs are not present
None

Case 1: 
Power switch
ON
Engine
Running
Battery voltage
8 V or more

Case 2: 
Internal engine OFF timer (elapsed time from engine stop)
10 to 30 minutes
Battery voltage
8 V or more
Power switch
ON

Case 3: 
Internal engine OFF timer (elapsed time from engine stop)
40 minutes or more
Battery voltage
8 V or more
Power switch
ON

TYPICAL MALFUNCTION THRESHOLDS


Case 1: 
Soak timer measurement when ECM (included in the hybrid vehicle control ECU) CPU clock counts 10 minutes
Less than 7 minutes or more than 13 minutes

Case 2: 
ECM (included in the hybrid vehicle control ECU) had the started record by internal engine OFF timer
YES

Case 3: 
ECM (included in the hybrid vehicle control ECU) had the starter record by internal engine OFF timer
NO

INSPECTION PROCEDURE

HINT:
  1. DTC P2610 is set if an internal ECM (included in the hybrid vehicle control ECU) problem is detected. Diagnostic procedures are not required. ECM replacement is required.
  2. Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

1.REPLACE HYBRID VEHICLE CONTROL ECU
  1. Replace the hybrid vehicle control ECU (Click here).


NEXT


2.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Clear the DTCs (Click here).

  1. Start the engine and wait for 10 minutes or more.

  1. On the Techstream, enter the following menu items: Powertrain / Engine and ECT / Trouble Codes.

  1. If no pending DTC is displayed, the repair has been successfully completed.


NEXT

END