SIDE AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL SIDE AIRBAG SENSOR |
Check that the power switch is off.
Check that the battery negative (-) cable is disconnected.
![]() |
Install the side airbag sensor with the bolt and pin.
Check that there are no loose parts after installing the side airbag sensor.
Connect the connector to the side airbag sensor.
| 2. INSTALL LOWER CENTER PILLAR GARNISH |
![]() |
Engage the 2 claws and the 2 clips, and install the lower center pillar garnish LH.
| 3. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the alignment mark (red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.
| 4. INSTALL REAR DOOR SCUFF PLATE |
![]() |
Engage the guide, 3 clips and 5 claws, and install the rear door scuff plate LH.
| 5. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the alignment mark (blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
| 6. INSTALL FRONT DOOR SCUFF PLATE |
![]() |
Engage the guide and the 8 claws, and install the front door scuff plate LH.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).