Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE


    B173224
  1. Disengage the 8 claws and guide, and remove the front door scuff plate LH.



4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B173234
  1. Remove the front door opening trim weatherstrip LH.



5. REMOVE REAR DOOR SCUFF PLATE


    B173228
  1. Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.



6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    B173232
  1. Remove the rear door opening trim weatherstrip LH.



7. REMOVE LOWER CENTER PILLAR GARNISH


    B173230
  1. Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.



8. REMOVE SIDE AIRBAG SENSOR


    C165113
  1. Disconnect the connector from the side airbag sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the bolt and disengage the pin, and remove the side airbag sensor.

    NOTICE:
    Loosen the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.