FRONT AIRBAG SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 11 clips and cool air intake duct seal.
| 4. REMOVE RADIATOR GRILLE |
![]() |
Put protective tape around the radiator grille.
![]() |
Remove the 2 bolts and 4 clips.
![]() |
Disengage the 6 claws and 4 guides, and remove the radiator grille.
| 5. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light) |
![]() |
Put protective tape around the front bumper assembly.
![]() |
Remove the screw.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the 7 screws and clip.
![]() |
Disengage the 4 claws and disconnect the front bumper assembly.
Remove the front bumper assembly.
| 6. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light) |
![]() |
Put protective tape around the front bumper assembly.
![]() |
Remove the screw.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the 7 screws and clip.
![]() |
Disengage the 4 claws and disconnect the front bumper assembly.
Disconnect each fog light connector, and then remove the front bumper assembly.
| 7. REMOVE REAR FENDER SPLASH SHIELD SUB-ASSEMBLY |
![]() |
Disengage the 3 clips and 3 guides, and remove the rear fender splash shield sub-assembly.
| 8. REMOVE HEADLIGHT ASSEMBLY |
![]() |
Remove the bolt and 2 screws.
Disengage the claw and disconnect the headlight assembly.
![]() |
Disengage the clamp.
Disconnect the connectors and remove the headlight assembly.
| 9. REMOVE FRONT AIRBAG SENSOR |
![]() |
Disconnect the connector from the front airbag sensor.
Remove the 2 bolts.
Disengage the 2 claws and pin, and remove the front airbag sensor from the body.