Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › DRIVER SIDE KNEE AIRBAG ASSEMBLY

DRIVER SIDE KNEE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
  1. Check that the power switch is off.

  1. Check that the battery negative (-) cable is disconnected.

    CAUTION:
    Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.



    C165102
  1. Install the DLC3 to the driver side knee airbag assembly with the 2 claws.



    C168061
  1. Connect the connector to the driver side knee airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    C168059
  1. Support the driver side knee airbag assembly with one hand as shown in the illustration.



    C165099
  1. Temporarily install the driver side knee airbag assembly with the 2 hooks.



    C165098
  1. Install the driver side knee airbag assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B173009
  1. Connect the hood lock control cable assembly.

  1. Connect each connector and the aspirator duct.



    B173021
  1. Engage the 3 claws and 10 clips.

  1. Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.



3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    B173227
  1. Engage the claw and clip, install the cowl side trim sub-assembly LH.

  1. Install the clip.



4. INSTALL FRONT DOOR SCUFF PLATE LH


    B173224
  1. Engage the guide and the 8 claws, and install the front door scuff plate LH.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).