Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › DRIVER SIDE KNEE AIRBAG ASSEMBLY

DRIVER SIDE KNEE AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH


    B173224
  1. Disengage the 8 claws and guide, and remove the front door scuff plate LH.



4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B173227
  1. Remove the clip.

  1. Disengage the clip and claw, and remove the cowl side trim sub-assembly LH.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    B173021
  1. Remove the 2 bolts <B>.

  1. Disengage the 3 claws and 10 clips.



    B173009
  1. Disconnect each connector and the aspirator duct.

  1. Disconnect the hood lock control cable assembly and remove the lower instrument panel finish panel sub-assembly.



6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY


    C165098
  1. Remove the 4 bolts.



    C165099
  1. Disengage the 2 hooks.



    C168059
  1. Pull out the driver side knee airbag assembly from the vehicle and support the driver side knee airbag assembly with one hand as shown in the illustration.

    NOTICE:
    When removing the driver side knee airbag assembly, do not pull the airbag wire harness.



    C168060E01
  1. Using a screwdriver with the tip wrapped with protective tape, disconnect the driver side knee airbag connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    C165102
  1. Disengage the 2 claws and separate the DLC3 from the driver side knee airbag assembly.