Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0604    Internal Control Module Random Access Memory (RAM) Error

for Preparation Click here


DESCRIPTION

The ECM (included in the hybrid vehicle control ECU) continuously monitors its internal memory status. This self-check ensures that the ECM is functioning properly. It is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect Random Access Memory (RAM) errors. If outputs from these CPUs are different and deviate from the standards, the ECM will illuminate the MIL and set a DTC immediately.

DTC
DTC Setting Condition
Trouble Area
P0604
ECM (included in the hybrid vehicle control ECU) RAM errors
(1 trip detection logic)
Hybrid vehicle control ECU

MONITOR STRATEGY


Related DTC
P0604: ECM (included in the hybrid vehicle control ECU) RAM error
Required Sensors/Components
ECM (included in the hybrid vehicle control ECU)
Frequency of Operation
Continuous
Duration
6 times
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None

TYPICAL MALFUNCTION THRESHOLDS


Main CPU and sub CPU mirroring
Fail

INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC P0604)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off and turn the Techstream off.

  1. Disconnect the battery negative terminal and wait for 1 minute.

  1. Connect the battery negative terminal.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    P0604
    A
    No output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)