Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Yaw Rate Sensor Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Yaw Rate Sensor Communication Stop Mode
  1. "Yaw Rate/Decelerate Sensor" is not displayed on "CAN Bus Check" screen of Techstream
  2. "Yaw Rate Sensor Communication Stop Mode" in "DTC COMBINATION TABLE"
  1. Power source circuit of yaw rate sensor
  2. Yaw rate sensor branch wire or connector
  3. Yaw rate sensor

WIRING DIAGRAM


C126215E36


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistance of the CAN main wires and CAN branch wires.
  2. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If the doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.

1.CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE)
  1. Turn the power switch off.

  1. Disconnect the yaw rate sensor connector.



    C165630E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    O6-3 (CANH) - O6-2 (CANL)
    Power switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE YAW RATE SENSOR BRANCH WIRE OR CONNECTOR
OK


2.CHECK WIRE HARNESS (IG, GND)
  1. Disconnect the yaw rate sensor connector.



    C165630E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    O6-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O6-4 (IG) - Body ground
    Power switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE YAW RATE SENSOR (Click here)