Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › FRONT CIRCUIT BREAKER SENSOR

FRONT CIRCUIT BREAKER SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here)



2. REMOVE NO. 2 ENGINE ROOM SIDE COVER LH


    A173813
  1. Remove the engine room side cover.



3. REMOVE COOL AIR INTAKE DUCT SEAL
  1. Remove the 11 clips and cool air intake duct seal.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A175875
  1. Remove the 2 bolts, 4 clamps and air cleaner cap sub-assembly.

  1. Remove the air cleaner filter element from the air cleaner case.



5. REMOVE NO. 1 CIRCUIT BREAKER SENSOR


    A173814
  1. Remove the bolt and disconnect the bracket.



    A175951
  1. Move the outer section to the wire harness side as illustrated, then disconnect the No. 1 circuit breaker sensor connector.

  1. Disconnect the clamp.



    A181831
  1. Remove the 2 bolts and No. 1 circuit breaker sensor from the inverter with converter assembly.