FUEL TANK > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT FLOOR COVER LH |
| 4. REMOVE FRONT CENTER FLOOR COVER |
| 5. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
| 6. REMOVE NO. 3 FRONT FLOOR HEAT INSULATOR |
![]() |
Remove the 5 nuts and No. 3 front floor heat insulator.
| 7. REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY |
![]() |
Disengage the 4 grommets.
Remove the screw and No. 1 fuel tank protector sub-assembly.
| 8. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Remove the nut and disconnect the No. 3 parking brake cable assembly.
| 9. DISCONNECT FUEL TANK WIRE |
![]() |
Separate the fuel tank wire connector from the bracket.
Disconnect the 2 connectors.
| 10. DISCONNECT FUEL TANK VENT HOSE |
![]() |
Disconnect the charcoal canister fuel hose from the fuel vapor containment valve.
Pinch the retainer and pull out the quick connector with the quick connector pushed to the pipe side to disconnect the charcoal canister fuel hose from the fuel vapor containment valve.
| 11. DISCONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Pinch the tabs of the retainer to disengage the lock claws and pull the retainer down as shown in the illustration.
Pull out the fuel pump tube.
| 12. DISCONNECT NO. 1 FUEL TANK BREATHER TUBE |
![]() |
Remove the checker of the No. 1 fuel tank breather tube connector.
Pinch the retainer of the No. 1 fuel tank breather tube connector, and pull out the No. 1 fuel tank breather tube connector to disconnect the No. 1 fuel tank breather tube from the fuel tank.
| 13. REMOVE FUEL TANK ASSEMBLY |
![]() |
Set an engine lifter to the fuel tank.
Remove the fuel filler pipe clamp and fuel tube connector from the fuel tank inlet pipe.
![]() |
Remove the 4 bolts and the fuel tank bands.
Operate the engine lifter, and disconnect the fuel inlet pipe.
Operate the engine lifter, and remove the fuel tank.
| 14. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
![]() |
Disconnect the fuel pump connector (A).
Disconnect the clamp and vapor pressure sensor connector (B).
![]() |
Remove the tube joint clip and clamp, and pull out the fuel pump tube.
![]() |
Remove the 8 bolts, fuel tank vent tube set plate and fuel pump connector plate.
![]() |
Pull out the fuel suction tube assembly from the fuel tank.
Remove the gasket from the fuel suction tube assembly.
| 15. DRAIN FUEL |
| 16. REMOVE FUEL VAPOR CONTAINMENT VALVE |
Disconnect the connector.
![]() |
Remove the 2 nuts from the fuel vapor containment valve.
![]() |
Push the fuel tank vent hose to the fuel tank to release the lock pin.
Pinch portion A.
Pull out the fuel tank vent hose.
Remove the fuel vapor containment valve from the fuel tank.
| 17. REMOVE FUEL TANK WIRE |
![]() |
Disconnect the 4 clamps, and remove the fuel tank wire.
| 18. REMOVE FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Remove the fuel pump tube from the clamp.
| 19. REMOVE FUEL HOSE CLAMP |
![]() |
Remove the 2 clamps of the fuel pump tube from the fuel tank.
![]() |
Remove the clamp from the fuel tank.
| 20. REMOVE FUEL TANK CUSHION |
![]() |
Remove the 8 fuel tank cushions from the fuel tank.