Home › STEERING › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > Unlock Position Sensor Signal Circuit

for Preparation Click here


DESCRIPTION

The unlock position sensor is one of the components of the steering lock actuator assembly. The sensor switch contact closes when the steering lock is released. The steering lock release signal is then sent to the main body ECU. Receiving the signal, the ECU permits engine start. (This prevents the engine from being started with the steering locked.)

WIRING DIAGRAM


C113485E14


INSPECTION PROCEDURE

1.INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)


    C157849E11
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D11-4 (SLP1) - D11-2 (SGND)
    1. Power switch off
    2. Power switch on (ACC or IG)
    Below 1 V



NG
Go to step 2
OK

CHECK SMART KEY SYSTEM (Click here)  

2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU)


    C157851E08
  1. Disconnect the D11 connector from the steering lock actuator assembly.

  1. Disconnect the D8 connector from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D11-4 (SLP1) - D8-18 (SLP)
    Always
    Below 1 Ω
    D11-4 (SLP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)