Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

SMART KEY SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the push-button start function.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Running conditions, driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use Techstream to check if the CAN Communication System is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Delete DTCs.

    3. Recheck for DTCs.

      Result:
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccurs
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.INSPECT BASIC OPERATION
    1. Turn the power switch on (READY) and check that the hybrid control system starts normally. Make sure that the brake pedal is depressed and the shift position is P at this time.

    2. Check that the power switch mode can be changed by pushing the power switch.

      HINT:
      Without depressing the brake pedal, push the power switch repeatedly. power switch mode should turn from off to on (ACC) to on (IG) and back to off.
      With the brake pedal depressed, push the power switch repeatedly. Power switch mode should turn to on (READY) from any status.

      OK:
      Hybrid control system starts normally.


    NEXT


    7.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is not listed in the problem symptoms table
      A
      Fault is listed in the problem symptoms table
      B



    B.
    Go to step 9
    A


    8.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. TERMINALS OF ECU (Click here).

    2. DATA LIST/ACTIVE TEST (Click here).


    NEXT


    9.REPAIR OR REPLACE

      NEXT


      10.CONFIRMATION TEST

        NEXT

        END