Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A02-719    Motor Electronics Coolant Temperature Sensor Circuit Low

DTC    P0A03-720    Motor Electronics Coolant Temperature Sensor Circuit High

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU detects HV coolant temperature using the coolant temperature sensor built into the inverter. The inverter cooling system is the same as that for the MG2 and MG1, and operates independently of the engine cooling system. The hybrid vehicle control ECU controls the inverter cooling system to prevent overheating based on signals from the coolant temperature sensor. The ECU also monitors cooling system operation and detects malfunctions in the HV coolant temperature sensor and the circuit.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A02
719
Short to GND in the HV coolant temperature sensor circuit
Inverter with converter assembly
P0A03
720
Open or short to +B in the HV coolant temperature sensor circuit

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals. After waiting for 5 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.

HINT:
Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

1.CHECK CONNECTOR CONNECTION CONDITION (MG ECU CONNECTOR)

CAUTION:
Be sure to wear insulated gloves.

  1. Turn the power switch off.

  1. Remove the service plug grip (Click here).

    NOTICE:
    After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

  1. Remove the inverter cover (Click here).

    NOTICE:
    1. Wrap the round interlock terminal for the inverter cover with insulating tape to prevent it from shorting to ground.
    2. Be sure to prevent coolant in the inverter reserve tank from entering the inverter.
    3. Removing the inverter cover causes the MG ECU board to be exposed. Therefore, temporarily install the inverter cover for each area to be inspected.



    A170989E01
  1. Check the connections of the MG ECU connectors.

    OK:
    The connectors are connected securely and there are no contact problems.



NG
CONNECT SECURELY
OK

REPLACE INVERTER WITH CONVERTER ASSEMBLY (Click here)