DTC P0A09-265 DC / DC Converter Status Circuit Low Input |
DTC P0A10-263 DC / DC Converter Status Circuit High Input |

| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A09 | 265 | Open or GND short in NODD signal circuit of DC/DC converter |
|
| P0A10 | 263 | +B short in NODD signal circuit of DC/DC converter |

| 1.CHECK CONNECTOR CONNECTION CONDITION (MG ECU CONNECTOR) |
Turn the power switch off.
Remove the service plug grip (Click here).
Remove the inverter cover (Click here).
![]() |
Check the connections of the MG ECU connectors.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - MG ECU) |
Check that the service plug grip is not installed.
Disconnect the A43 connector from the hybrid vehicle control ECU.
Disconnect the A42 connector from the MG ECU.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A43-11 (NODD) - Body ground | Power switch on (IG) | Below 1 V |
Turn the power switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A43-11 (NODD) - A42-33 (NODD) | Power switch off | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| A43-11 (NODD) or A42-33 (NODD) - Body ground | Power switch off | 10 kΩ or more |
|
| ||||
| OK | ||
| ||