Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A0F-204    Engine Failed to Start

DTC    P0A0F-205    Engine Failed to Start

DTC    P0A0F-533    Engine Failed to Start

DTC    P0A0F-534    Engine Failed to Start

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU contains an HV CPU and an engine CPU. If a signal indicating an abnormality is received from the engine CPU, the HV CPU performs fail-safe control.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A0F
204
Abnormal signal input from the engine CPU (abnormal engine output)
  1. Hybrid vehicle control ECU
  2. SFI system
205
Abnormal signal input from the engine CPU (engine is unable to start)
533
Abnormal signal input from the engine CPU (abnormal engine output when running out of fuel)
534
Abnormal signal input from the engine CPU (fuel level not sufficient to start the engine)

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (SFI SYSTEM)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Engine Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    DTCs are not output.
    A
    DTCs are output.
    B



B
GO TO DTC CHART (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)