Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID VEHICLE CONTROL ECU

HYBRID VEHICLE CONTROL ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.



3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B172999
  1. Disengage the 3 claws.

  1. Disengage the 2 guides and remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B168370
  1. Remove the 2 bolts <B> and 3 screws <E>.

  1. Disengage the 4 claws and 3 clips.

  1. Disconnect each connector and clamp, and remove the lower instrument panel sub-assembly.



6. REMOVE HYBRID VEHICLE CONTROL ECU
  1. Disconnect the 2 connectors from the certification ECU (Smart Key ECU Assembly). (w/ Smart Key System)



    A175879
  1. Disconnect the clamp. (w/ Smart Key System)

  1. Remove the 2 nuts and certification ECU (Smart Key ECU Assembly). (w/ Smart Key System)



    A175937
  1. Disconnect the 6 connectors from the hybrid vehicle control ECU.

  1. Remove the 2 nuts, bolt and hybrid vehicle control ECU.



    A177446
  1. Remove the 4 screws and 2 brackets.