Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1A-151    Generator Control Module

DTC    P0A1A-155    Generator Control Module

DTC    P0A1A-156    Generator Control Module

DTC    P0A1A-166    Generator Control Module

DTC    P0A1A-658    Generator Control Module

DTC    P0A1A-659    Generator Control Module

DTC    P0A1A-791    Generator Control Module

for Preparation Click here


DESCRIPTION

The MG ECU monitors its internal operation and detects the following malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1A
151
Run pulse error
Inverter with converter assembly (MG ECU)
155
A/D error
156
ROM-RAM error
166
R/D converter NM stop error
658
ALU error
659
Communication error (from MG1 to MG2)
791
R/D converter communication error

MONITOR DESCRIPTION

The MG ECU performs many diagnostic tests to verify proper operation of internal ECU systems. In one of these diagnostics, the MG ECU checks the result of the generator CPU self-test. If the MG ECU detects a "Fail" from the generator CPU self-test, it will conclude that there is an internal malfunction in the generator CPU. The hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1A (INF 151): RUN pulse malfunction
P0A1A (INF 155): A/D malfunction (1MG CPU)
P0A1A (INF 156): RAM and ROM destruction
P0A1A (INF 166): RD Converter NM Signal Stop abnormality
P0A1A (INF 658): MG CPU ALU malfunction
P0A1A (INF 659): MG CPU communication malfunction (1MG CPU to 2MG CPU)
P0A1A (INF 791): R/D converter communication error
Required sensors / components
Motor Generator control ECU (MG ECU)
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Motor Generator control ECU (MG ECU)
Internal error

COMPONENT OPERATING RANGE


Motor Generator control ECU (MG ECU)
DTC P0A1A (INF 151/155/156/166/658/659/791) is not detected

INSPECTION PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY
  1. Replace the inverter with converter assembly (Click here).


NEXT

COMPLETED