Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1B-163    Drive Motor "A" Control Module

DTC    P0A1B-164    Drive Motor "A" Control Module

DTC    P0A1B-511    Drive Motor "A" Control Module

DTC    P0A1B-512    Drive Motor "A" Control Module

DTC    P0A1B-794    Drive Motor "A" Control Module

for Preparation Click here


DESCRIPTION

The MG ECU located in the inverter with converter assembly monitors its internal operation and it will set DTCs when it detects malfunctions. If any of the following DTCs are output, replace the inverter with converter assembly.

HINT:
The term "drive motor A" indicates MG2.


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1B
163
Power source [24 V] error
Inverter with converter assembly (MG ECU)
164
Power source [-5 V] error
511
Power source [2.5 V] error
512
Power source [5 VA] error
794
R/D converter communication error

MONITOR DESCRIPTION

The MG ECU performs diagnostic monitoring to verify proper operation of internal ECU systems. In one of these monitors, the MG ECU monitors the power supply for the motor main CPU. If the MG ECU detects a failure in the power supply of the motor main CPU, the hybrid vehicle control ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1B (INF 163): Motor CPU power malfunction (24V)
P0A1B (INF 164): Motor CPU power malfunction (-5V)
P0A1B (INF 511): Motor CPU power malfunction (2.5V)
P0A1B (INF 512): Motor CPU power malfunction (5VA)
P0A1B (INF 794): R/D converter communication error
Required sensors / components
Motor Generator control ECU (MG ECU)
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Motor Generator control ECU (MG ECU)
Internal error

COMPONENT OPERATING RANGE


Motor Generator control ECU (MG ECU)
DTC P0A1B (INF 163/164/511/512/794) is not detected

INSPECTION PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY
  1. Replace the inverter with converter assembly (Click here).


NEXT

COMPLETED