Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1C-706    Drive Motor "B" Control Module

DTC    P0A1C-708    Drive Motor "B" Control Module

DTC    P0A1C-709    Drive Motor "B" Control Module

DTC    P0A1C-710    Drive Motor "B" Control Module

DTC    P0A1C-711    Drive Motor "B" Control Module

DTC    P0A1C-713    Drive Motor "B" Control Module

DTC    P0A1C-797    Drive Motor "B" Control Module

for Preparation Click here


DESCRIPTION

The MG ECU monitors its internal operation and detects malfunctions.

HINT:
The term "drive motor B" indicates MGR.


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1C
706
A/D error
Inverter with converter assembly (MG ECU)
708
ROM-RAM error
709
Run pulse error
710
ALU error
711
Communication error (from MGR to MG2)
713
R/D converter NM stop error
797
R/D converter communication error

MONITOR DESCRIPTION

The MG ECU performs many diagnostic tests to verify proper operation of internal ECU systems. In one of these diagnostics, the MG ECU checks the result of the rear motor CPU self-test. If the MG ECU detects a "Fail" from the rear motor CPU self-test, it will conclude that there is an internal malfunction in the rear motor CPU. The hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1C (INF 706): A/D malfunction (3GM CPU)
P0A1C (INF 708): RAM and ROM destruction
P0A1C (INF 709): RUN pulse malfunction
P0A1C (INF 710): MG CPU ALU malfunction
P0A1C (INF 711): MG CPU communication malfunction (3MG CPU to 2MG CPU)
P0A1C (INF 713): RD Converter NM Signal Stop abnormality
P0A1C (INF 797): R/D converter communication error
Required sensors / components
Motor Generator control ECU (MG ECU)
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Motor Generator control ECU (MG ECU)
Internal error

COMPONENT OPERATING RANGE


Motor Generator control ECU (MG ECU)
DTC P0A1C (INF 706/708/709/710/711/713/797) is not detected

INSPECTION PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY
  1. Replace the inverter with converter assembly (Click here).


NEXT

COMPLETED