Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-390    Hybrid Powertrain Control Module

DTC    P3004-133    Power Cable Malfunction

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors its internal operation and detects malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
390
Charge control error
Hybrid vehicle control ECU
P3004
133
A high-voltage wiring system error signal is detected in the hybrid vehicle control ECU

MONITOR DESCRIPTION

When hybrid vehicle control ECU detects that the HV battery has been overcharged, the hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 390): Abnomal battery charge
Required sensors / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property

TYPICAL MALFUNCTION THRESHOLDS


Hybrid vehicle control ECU
Internal error

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 390) is not detected

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0A1D-390 or P3004-133 only is output.
    A
    DTCs other than P0A1D-390 or P3004-133 are output.
    B



B
GO TO DTC CHART (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)