Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1F-129    Battery Energy Control Module

for Preparation Click here


DESCRIPTION

The battery smart unit sends HV battery voltage information to the hybrid vehicle control ECU via serial communication.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1F
129
HV battery voltage circuit malfunction
Battery smart unit

A113867E04


MONITOR DESCRIPTION

The hybrid vehicle control ECU calculates the differences between the received HV battery voltage, boost converter voltage, and inverter voltage. If any of the differences exceed prescribed values, the hybrid vehicle control ECU determines that there is a malfunction in the battery voltage circuit. When the hybrid vehicle control ECU detects a malfunction, it illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1F (INF 129): Voltage (VB) sensor deviation
Required sensors / components
Battery smart unit
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Battery smart unit
DTC P0A1F (INF129) is not detected.

INSPECTION PROCEDURE

NOTICE:
Performing the check procedures for a long time with the shift lever in the N position may cause the HV battery to discharge and DTC P3000-388 to be stored.

HINT:
If it is necessary to replace the battery smart unit after performing troubleshooting, voltages need to be confirmed after installing the new battery smart unit. To confirm normal operation, compare the HV battery voltage (Power Resource VB), the pre-boost voltage (VL-Voltage before Boosting), and post-boost voltage (VH-Voltage after Boosting) with the power switch on (READY) and the shift lever in the N position.
When the system is normal, the Power Resource VB, VL-Voltage before Boosting, and VH-Voltage after Boosting values should be almost equal (voltage boosting will not occur when the shift lever is in neutral).

1.REPLACE BATTERY SMART UNIT
  1. Replace the battery smart unit (Click here).


NEXT

COMPLETED