Home › RESTRAINTS › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the seat belt warning system.
  2. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Use Techstream to check if the CAN Communication System is functioning normally.

      Result:
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE

      HINT:
      (Click here).


    NEXT


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. DATA LIST / ACTIVE TEST (Click here).

    2. Terminals of ECU (Click here).

    3. On-vehicle Inspection (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END