DTC B1473/73 A/C Inverter Start-up Signal System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1473/73 | Open or short in A/C inverter start-up signal system circuit |
|

| 1.CHECK CAN COMMUNICATION SYSTEM |
Using the Techstream, check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Check if DTCs for the air conditioning system and the hybrid control system are output using the Techstream.
| Result | Proceed to |
| Only DTC B1473 is output | A |
| DTCs B1473 and P3108 are output simultaneously (B1498 is not output) | |
| DTCs B1473 and B1498 are output simultaneously (P3108 is not output) | B |
| DTCs B1473, B1498 and P3108 are output simultaneously | |
| DTCs other than P3108 are output for hybrid control system | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - COMPRESSOR WITH MOTOR ASSEMBLY) |
Disconnect the connector from the hybrid vehicle control ECU.
![]() |
Disconnect the connector from the compressor with motor assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| B2-18 (STB) - B48-4 (STB1) | Always | Below 1 Ω |
| B2-18 (STB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.INSPECT COMPRESSOR WITH MOTOR ASSEMBLY |
Reconnect the connector to the compressor with motor assembly.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection (Symbols) | Switch Condition | Specified Condition |
| B2-18 (STB) - Body ground | Power switch on (IG) | 11 to 14 V |
| B2-18 (STB) - Body ground | Power switch off | Below 1 V |
|
| ||||
| OK | ||
| ||