Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A79-701    Drive Motor "B" Inverter Performance

for Preparation Click here


DESCRIPTION

Refer to the description of the inverter .
If the inverter receives a rear motor gate shutdown signal from the MG ECU, it will turn all power transistors off which are activating MGR to forcibly stop MGR operation.
The MG ECU monitors rear motor gate shutdown signals and detects a malfunction.

HINT:
The term "drive motor B" indicates MGR.


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A79
701
Rear motor gate shutdown (RSDN) signal malfunction
Inverter with converter assembly (MG ECU)

MONITOR DESCRIPTION

The hybrid vehicle control ECU monitors the rear motor gate shutdown (RSDN) signal. If the hybrid vehicle control ECU detects a fault in the RSDN signal, the hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A79 (INF 701): Rear motor gate shutdown signal line malfunction
Required sensors / components
Rear motor inverter
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Rear motor inverter
DTC P0A79 (INF 701) is not detected

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0A79-701 only is output.
    A
    DTCs except P0A79-701 are output.
    B



B
GO TO DTC CHART (Click here)
A

REPLACE INVERTER WITH CONVERTER ASSEMBLY (Click here)