Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A7A-520    Generator Inverter Performance

for Preparation Click here


DESCRIPTION

Refer to the description of the inverter. (Click here)
The MG ECU shuts down the inverter generator gate based on a generator gate shutdown command received from the hybrid vehicle control ECU. The MG ECU monitors inverter generator gate shutdown signals and generator gate conditions, and sends this information to the hybrid vehicle control ECU. If a command and monitor result do not match, the hybrid vehicle control ECU will store this DTC.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A7A
520
Generator gate shutdown (GSDN signal malfunction)
Inverter with converter assembly (MG ECU)

MONITOR DESCRIPTION

The hybrid vehicle control ECU monitors the generator gate shutdown (GSDN) signal. If the hybrid vehicle control ECU detects a fault in the GSDN signal, hybrid vehicle control ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A7A (INF 520): Generator gate shutdown signal line malfunction
Required sensors / components
Generator inverter
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Generator inverter
DTC P0A7A (INF 520) is not detected

INSPECTION PROCEDURE

1.DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Read output DTCs.

Result:
Result
Proceed to
P0A7A-520 only is output
A
Except P0A7A-520 are output
B



B
GO TO DTC CHART (Click here)
A

REPLACE INVERTER WITH CONVERTER ASSEMBLY (Click here)