Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A7A-522    Generator Inverter Performance

for Preparation Click here


DESCRIPTION

Refer to the description of the inverter .
If the inverter receives a generator gate shutdown signal from the MG ECU, it will turn all power transistors off which are activating MG1 to forcibly stop MG1 operation. The MG ECU monitors the generator gate shutdown signal line and detects a malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A7A
522
Generator inverter gate malfunction
Inverter with converter assembly (MG ECU)

HINT:
  1. If DTC P0A7A-522 is output, the hybrid system cannot be restarted until the DTC is cleared.
  2. If the malfunction is not reproduced, turn the power switch on (READY) and leave the vehicle for 1 minute with the shift lever in the P or N position in order to easily reproduce the malfunction.


MONITOR DESCRIPTION

The MG ECU monitors the current to MG1. If the current passes to MG1 while the vehicle is stopped with the power switch on (IG) or the shift lever in the N position, the MG ECU will interpret this as a malfunction. The hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A7A (INF 522): Malfunction of inverter gate shutdown circuit
Required sensors / components
Generator inverter
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Generator inverter
DTC P0A7A (INF 522) is not detected

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals. After waiting for 5 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.

HINT:
Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

1.CHECK CONNECTOR CONNECTION CONDITION (MG ECU CONNECTOR)

CAUTION:
Be sure to wear insulated gloves.

  1. Turn the power switch off.

  1. Remove the service plug grip (Click here).

    NOTICE:
    After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

  1. Remove the inverter cover (Click here).

    NOTICE:
    1. Wrap the round interlock terminal for the inverter cover with insulating tape to prevent it from shorting to ground.
    2. Be sure to prevent coolant in the inverter reserve tank from entering the inverter.
    3. Removing the inverter cover causes the MG ECU board to be exposed. Therefore, temporarily install the inverter cover for each area to be inspected.



    A170989E01
  1. Check the connections of the MG ECU connectors.

    OK:
    The connectors are connected securely and there are no contact problems.



NG
CONNECT SECURELY
OK

REPLACE INVERTER WITH CONVERTER ASSEMBLY (Click here)