DTC P0A94-561 DC / DC Converter Performance |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0A94 | 561 | Abnormal boost converter gate shutdown (CSDN) signal | Inverter with converter assembly (MG ECU) |
| Related DTCs | P0A94 (INF 561): Converter gate shutdown signal line malfunction |
| Required sensors / components | Boost converter |
| Frequency of operation | Continuous |
| Duration | TMC's intellectual property |
| MIL operation | Immediately |
| Sequence of operation | None |
| The monitor will run whenever the DTCs listed are not present | TMC's intellectual property |
| Other conditions belong to TMC's intellectual property | - |
| Boost converter overvoltage (OVL) signal circuit | Open or short |
| Boost converter | DTC P0A94 (INF 561) is not detected |
| 1.CHECK DTC OUTPUT (HV) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
| P0A94-561 only is output. | A |
| Except P0A94-561 is output. | B |
|
| ||||
| A | ||
| ||