Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A94-585    DC / DC Converter Performance

for Preparation Click here


DESCRIPTION

Refer to the description of the boost converter .

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A94
585
Boost converter voltage (VL) sensor performance problem
Inverter with converter assembly (MG ECU)

MONITOR DESCRIPTION

The hybrid vehicle control ECU monitors the boost converter voltage sensor signal. If the hybrid vehicle control ECU detects a fault in the sensor signal, hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A94 (INF 585): Voltage (VL) sensor deviation
Required sensors / components
Boost converter
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Boost converter
DTC P0A94 (INF 585) is not detected

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0A94-585 only is output.
    A
    Any of the following DTCs are also output.
    B


    DTC No.
    Relevant Diagnosis
    P0A1A (all INF codes) *1
    Generator Control Module
    P0A1B (all INF codes) *1
    Drive Motor "A" Control Module
    P0A1D (all INF codes) *1
    Hybrid Powertrain Control Module

    NOTICE:
    1. *1: If any INF codes are output for this DTC, refer to the corresponding diagnostic flowchart.
    2. P0A94-585 may be set due to a malfunction which also causes DTCs in the preceding table to be set. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.



B
GO TO DTC CHART (Click here)
A

REPLACE INVERTER WITH CONVERTER ASSEMBLY (Click here)