Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID VEHICLE CONTROL ECU

HYBRID VEHICLE CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL HYBRID VEHICLE CONTROL ECU


    A177446
  1. Install the 2 brackets with the 4 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



    A175937
  1. Install the hybrid vehicle control ECU with the 2 nuts and bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the 6 connectors to the hybrid vehicle control ECU.



    A175879
  1. Install the 2 nuts and certification ECU (Smart Key ECU Assembly). (w/ Smart Key System)

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the clamp. (w/ Smart Key System)

  1. Connect the 2 connectors to the certification ECU (Smart Key ECU Assembly). (w/ Smart Key System)



2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector and clamp.



    B168370
  1. Engage the 4 claws and 3 clips.

  1. Install the lower instrument panel sub-assembly with the 2 bolts <B> and 3 screws <E>.



3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B173000
  1. Engage the 2 guides.

  1. Engage the 3 claws and install the No. 2 instrument panel under cover sub-assembly.



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).