SEAT VARIABLE CUSHION SWITCH > REMOVAL |
| 1. REMOVE FRONT SEAT HEADREST ASSEMBLY |
![]() |
Press the headrest support button and pull up the headrest to its highest position as shown in the illustration.
![]() |
Insert a finger or screwdriver into the hole to release the lock. Pull the headrest up as shown in the illustration to remove it.
| 2. REMOVE FRONT OUTER SEAT TRACK COVER |
Operate the power seat switch knob and move the seat to the rearmost position.
![]() |
Disengage the 2 claws and remove the front outer seat track cover.
| 3. REMOVE FRONT INNER SEAT TRACK COVER |
![]() |
Disengage the 2 claws and remove the front inner seat track cover.
| 4. REMOVE REAR OUTER SEAT TRACK COVER |
Operate the power seat switch knob and move the seat to the foremost position.
![]() |
Disengage the 2 claws and remove the rear outer seat track cover.
| 5. REMOVE REAR INNER SEAT TRACK COVER |
![]() |
Disengage the 2 claws and remove the rear inner seat track cover.
| 6. REMOVE FRONT SEAT ASSEMBLY |
![]() |
Remove the 2 bolts on the rear side of the seat.
Operate the power seat switch knob and move the seat to the rearmost position.
![]() |
Remove the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the center position. Also, operate the power seat switch knob and move the seatback to the upright position.
Disconnect the cable from the negative (-) battery terminal.
Disconnect each connector under the front seat assembly.
Remove the front seat assembly.
| 7. REMOVE RECLINING POWER SEAT SWITCH KNOB |
![]() |
Using a screwdriver wrapped with protective tape, disengage the 2 claws and remove the reclining power seat switch knob.
| 8. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB |
![]() |
Using a screwdriver wrapped with protective tape, disengage the 4 claws and remove the slide and vertical power seat switch knob.
| 9. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY |
![]() |
Disengage the hooks.
![]() |
Remove the 5 screws.
Disengage the claw.
Disengage the guide and remove the front seat cushion shield assembly.
w/o Seat Cushion Front Edge Adjustment Function:
Disconnect the connector from the front power seat lumbar switch.
w/ Seat Cushion Front Edge Adjustment Function:
Disconnect the connector from the front power seat lumbar switch and the seat variable cushion switch.
Disengage each clamp.
| 10. REMOVE SEAT VARIABLE CUSHION SWITCH |
![]() |
Remove the 2 screws and the seat variable cushion switch.