INPUT SHAFT OIL SEAL > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY WITH HYBRID VEHICLE TRANSAXLE |
| 2. REMOVE MANIFOLD STAY |
![]() |
Remove the bolt, nut, and the manifold stay.
| 3. REMOVE HYBRID TRANSAXLE MASS DAMPER |
![]() |
Remove the bolt and transaxle mass damper.
| 4. REMOVE REAR ENGINE MOUNTING INSULATOR |
![]() |
Remove the 3 bolts and rear engine mounting insulator.
| 5. REMOVE FRONT FRAME ASSEMBLY |
![]() |
Remove the nut and separate the front engine mounting insulator.
![]() |
Remove the 2 nuts and separate the engine mounting insulators RH and LH.
| 6. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the front drive shaft assembly LH.
| 7. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Remove the bearing bracket hole snap ring from the drive shaft bearing bracket.
Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
| 8. REMOVE FLYWHEEL HOUSING UNDER COVER |
![]() |
Remove the 2 bolts and flywheel housing under cover.
| 9. SEPARATE ENGINE WIRE |
Remove the bolt and ground wire.
Disconnect the wire harnesses from the brackets.
Disconnect the connectors.

![]() |
Remove the 2 bolts and transmission case cover from the hybrid vehicle transaxle.
![]() |
Remove the 7 bolts and 7 brackets.
| 10. REMOVE AUTOMATIC TRANSMISSION CASE COVER |
![]() |
Remove the bolt and transmission control cable bracket.
Remove the bolt, clip and transmission case cover from the hybrid vehicle transaxle.
| 11. REMOVE FRONT ENGINE MOUNTING BRACKET |
![]() |
Remove the 3 bolts and engine mounting bracket.
| 12. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY |
![]() |
Remove the 8 bolts.
Separate and remove the hybrid vehicle transaxle.
| 13. REMOVE INPUT SHAFT OIL SEAL |
![]() |
Using a screwdriver with its tip taped, remove the oil seal.