THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble (Click here).
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM |
Use Techstream to check if the CAN Communication System is functioning normally (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 4.SYMPTOM SIMULATION |
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
If the fault is not listed in the problem symptoms table, proceed to A.
If the fault is listed in the problem symptoms table, proceed to B.
|
| ||||
| |||||
| 6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM |
System description (Click here)
Terminals of ECU (Click here)
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|