Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



CAN BUS CHECK
  1. Using the Techstream, select "CAN Bus Check" from "System Select".


CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT ADOPT CAN COMMUNICATION
  1. Systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle's optional settings. Check which systems (ECUs, sensors) are installed on the vehicle.

    HINT:
    ECUs and sensors that are connected to the LIN communication system and the local CAN system are also displayed.


    ECU/Sensor name
    Check method
    Hybrid vehicle control ECU
    Installed on all vehicles
    Combination meter
    Installed on all vehicles
    Skid control ECU
    Installed on all vehicles
    Steering angle sensor
    Installed on all vehicles
    Yaw rate sensor
    Installed on all vehicles
    Power steering ECU
    Installed on all vehicles
    Center airbag sensor assembly
    Installed on all vehicles
    Air conditioning amplifier
    Installed on all vehicles
    Main body ECU
    Installed on all vehicles
    Certification ECU
    Installed on all vehicles
    Tire pressure warning ECU
    Installed on all vehicles
    Navigation receiver assembly
    w/ Navigation system
    Back door ECU
    w/ Power back door system
    Accessory gateway
    w/ Remote engine start (dealer option)


DTC TABLE BY ECU

HINT:
  1. In the CAN communication system, CAN communication system DTCs can be displayed by the ECU using the Techstream.
  2. If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "HOW TO PROCEED WITH TROUBLESHOOTING" (Click here).

  1. HYBRID VEHICLE CONTROL ECU

    HINT:
    DTC communication uses the CAN communication system.

    HYBRID VEHICLE CONTROL ECU (HV) 
    DTC No.
    Detection Item
    U0100-211
    Lost Communication with ECM/PCM "A"
    U0100-212
    Lost Communication with ECM/PCM "A"
    U0100-530
    Lost Communication with ECM/PCM "A"
    U0100-774
    Lost Communication with ECM/PCM "A"
    U0100-784
    Lost Communication with ECM/PCM "A"
    U0129-220
    Lost Communication with Brake System Control Module
    U0129-222
    Lost Communication with Brake System Control Module
    U0129-528
    Lost Communication with Brake System Control Module
    U0129-529
    Lost Communication with Brake System Control Module
    U0140-146
    Lost Communication with Body Control Module
    U0164-827
    Lost Communication with A/C ECU

    HYBRID VEHICLE CONTROL ECU (ENGINE) 
    DTC No.
    Detection Item
    U0001
    Control Module Communication Bus Off
    U0293
    Lost Communication with HV Control Module
    1. Check for INFORMATION (Click here).
    2. U0110-159, U0110-160, U0110-656, and U0110-657 are not CAN communication system DTCs. Therefore, refer to the troubleshooting procedures for the hybrid control system (Click here).

  2. SKID CONTROL ECU

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    U0073
    Control Module Communication Bus Off
    U0123
    Lost Communication with Yaw Rate Sensor Module
    U0124
    Lost Communication with Lateral Acceleration Sensor Module
    U0126
    Lost Communication with Steering Angle Sensor Module
    U0293
    Lost Communication with HV Control Module

  3. AIR CONDITIONING AMPLIFIER

    HINT:
    1. DTC communication uses the CAN communication system.
    2. The following DTC is output only for current malfunctions.

    DTC No.
    Detection Item
    B1499
    Multiplex Communication Circuit

  4. COMBINATION METER

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    U0100
    Lost Communication with ECM/PCM "A"
    U0129
    Lost Communication with Brake System Control Module

  5. POWER STEERING ECU

    HINT:
    DTC communication uses the CAN system.

    DTC No.
    Detection Item
    U0073
    Control Module Communication Bus Off
    U0100
    Lost Communication with ECM
    U0129
    Lost Communication with Anti-lock Brake System (ABS) Control Module
    U0293
    Lost Communication with HV Control Module

  6. MAIN BODY ECU

    HINT:
    DTC communication uses the CAN system.

    DTC No.
    Detection Item
    U0127
    Lost Communication with Tire Pressure Monitor Module
    U0230
    Lost Communication with Rear Gate Module
    U0327
    Software Incompatibility with Vehicle Security Control Module
    U1002
    Lost Communication with Gateway Module

  7. TIRE PRESSURE WARNING ECU

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    C2179
    Tire Pressure Monitor ECU Communication Stop

  8. CENTER AIRBAG SENSOR

    HINT:
    The center airbag sensor is connected to the CAN communication system, but CAN communication DTCs are not output.

  9. STEERING ANGLE SENSOR

    HINT:
    The steering angle sensor is connected to the CAN communication system, but CAN communication DTCs are not output.

  10. YAW RATE SENSOR

    HINT:
    The yaw rate sensor is connected to the CAN communication system, but CAN communication DTCs are not output.

  11. CERTIFICATION ECU

    HINT:
    The certification ECU is connected to the CAN communication system, but CAN communication DTCs are not output.

  12. BACK DOOR ECU (w/ Power back door system)

    HINT:
    The certification ECU is connected to the CAN communication system, but CAN communication DTCs are not output.


DTC COMBINATION TABLE
  1. CAN No. 1 Bus

    DTC
    Trouble Mode
    Output from
    Output DTC
    Hybrid Vehicle Control ECU Communication Stop Mode
    Skid Control ECU Communication Stop Mode
    Steering Angle Sensor Communication Stop Mode
    Yaw Rate Sensor Communication Stop Mode
    Combination Meter ECU Communication Stop Mode
    Hybrid Vehicle Control ECU
    (HV)
    U0100-774
    ○*1
    X
    X
    X
    X
    U0100-784
    ○*1
    X
    X
    X
    X
    U0129-220
    ○*1
    ○
    X
    X
    X
    U0129-528
    ○*1
    ○
    X
    X
    X
    U0140
    ○*1
    X
    X
    X
    X
    U0164
    ○*1
    X
    X
    X
    X
    Hybrid Vehicle Control ECU
    (ENGINE)
    U0001*2
    X
    X
    X
    X
    X
    U0293*2
    X
    X
    X
    X
    X
    Skid Control ECU
    U0073
    X
    ○*1
    X
    X
    X
    U0123
    X
    ○*1
    X
    ○
    X
    U0124
    X
    ○*1
    X
    ○
    X
    U0126
    X
    ○*1
    ○
    X
    X
    U0293
    ○
    ○*1
    X
    X
    X
    Combination Meter
    U0100
    ○
    X
    X
    X
    ○*1
    U0129
    X
    ○
    X
    X
    ○*1
    Power Steering ECU
    U0100
    ○
    X
    X
    X
    X
    U0129
    X
    ○
    X
    X
    X
    U0293
    ○
    X
    X
    X
    X

    HINT:
    1. ○: Set
    2. X: Not set or may be set according to the malfunctioning part when one side of the CAN bus wire opens
    3. *1: Not set during communication error


    DTC
    Trouble Mode
    Output from
    Output DTC
    Air Conditioning Amplifier Communication Stop Mode
    Center Airbag Sensor Communication Stop Mode
    Power Steering ECU Communication Stop Mode
    Main Body ECU Communication Stop Mode
    Navigation Receiver Assembly Communication Stop Mode
    Hybrid Vehicle Control ECU
    (HV)
    U0100-774
    X
    X
    X
    X
    X
    U0100-784
    X
    X
    X
    X
    X
    U0129
    X
    X
    X
    X
    X
    U0131
    X
    X
    ○
    X
    X
    U0140
    X
    X
    X
    ○
    X
    U0164
    ○
    X
    X
    X
    X
    Hybrid Vehicle Control ECU
    (ENGINE)
    U0001*2
    X
    X
    X
    X
    X
    U0293*2
    X
    X
    X
    X
    X
    Skid Control ECU
    U0073
    X
    X
    X
    X
    X
    U0123
    X
    X
    X
    X
    X
    U0124
    X
    X
    X
    X
    X
    U0126
    X
    X
    X
    X
    X
    Combination Meter
    U0100
    X
    X
    X
    X
    X
    U0129
    X
    X
    X
    X
    X
    Power Steering ECU
    U0100
    X
    X
    ○*1
    X
    X
    U0129
    X
    X
    ○*1
    X
    X
    U0293
    X
    X
    ○*1
    X
    X

    HINT:
    1. ○: Set
    2. X: Not set or may be set according to the malfunctioning part when one side of the CAN bus wire opens
    3. *1: Not set during communication error
    4. *2: If only the following DTCs for the CAN communication system are output, refer to the troubleshooting procedures for the hybrid control system.
    5. Hybrid Vehicle Control ECU Communication Stop Mode (Click here)
    6. Skid Control ECU Communication Stop Mode (Click here)
    7. Steering Angle Sensor Communication Stop Mode (Click here)
    8. Yaw Rate Sensor Communication Stop Mode (Click here)
    9. Air Conditioning Amplifier Communication Stop Mode (Click here)
    10. Combination Meter Communication Stop Mode (See page
      Click here)
    11. Power Steering ECU Communication Stop Mode (Click here)
    12. Main Body ECU Communication Stop Mode (Click here)
    13. Center Airbag Sensor Communication Stop Mode (Click here)
    14. Navigation Receiver Assembly Communication Stop Mode (Click here)