DTC B1786 Front Occupant Classification Sensor RH Collision Detection |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1786 |
|
|

| 1.PERFORM ZERO POINT CALIBRATION |
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
|
| ||||
| OK | |
| 2.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
|
| ||||
| OK | |
| 3.CHECK DTC |
Turn the power switch on (IG).
Clear the DTCs stored in the occupant classification ECU (Click here).
Clear the DTCs stored in the center airbag sensor assembly (Click here).
Turn the power switch off.
Turn the power switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPLACE FRONT SEAT ASSEMBLY RH |
Turn the power switch off.
Disconnect the negative (-) terminal cable from the battery.
Replace the front seat assembly RH (Click here for power seat or Click here for manual seat).
| NEXT | |
| 5.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
|
| ||||
| OK | |
| 6.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
|
| ||||
| OK | |
| 7.CHECK DTC |
Turn the power switch on (IG).
Clear the DTCs stored in the occupant classification ECU (Click here).
Clear the DTCs stored in the center airbag sensor assembly (Click here).
Turn the power switch off.
Turn the power switch on (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 8.REPLACE OCCUPANT CLASSIFICATION ECU |
Turn the power switch off.
Disconnect the negative (-) terminal cable from the battery.
Replace the occupant classification ECU (Click here).
| NEXT | |
| 9.PERFORM ZERO POINT CALIBRATION |
Connect the negative (-) terminal cable to the battery.
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Using Techstream, perform "zero point calibration" (Click here).
| NEXT | |
| 10.PERFORM SENSITIVITY CHECK |
Using Techstream, perform "sensitivity check" (Click here).
| NEXT | ||
| ||