Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Remove the engine assembly with transaxle (Click here).



2. REMOVE NO. 1 FRONT STABILIZER BRACKET LH


    C167140
  1. Remove the 2 bolts and the No. 1 front stabilizer bracket LH from the front frame assembly.



3. REMOVE NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



4. REMOVE FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY


5. REMOVE POWER STEERING LINK ASSEMBLY


    C174974
  1. Remove the 2 bolts, 2 nuts, and power steering link assembly.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



6. REMOVE ENGINE MOUNTING ABSORBER SUB-ASSEMBLY


    A175946
  1. Remove the 2 bolts, 2 nuts and engine mounting absorber sub-assembly.



7. SEPARATE REAR ENGINE MOUNTING INSULATOR


    C179023
  1. Remove the 2 bolts and separate the rear engine mounting insulator.



8. REMOVE FRONT FRAME ASSEMBLY


  1. Remove the 5 hole plugs.


    A172972E01



  1. Remove the 9 nuts and separate the engine with transaxle from the front frame assembly.


    A172973E01



9. REMOVE FRONT LOWER SUSPENSION ARM


    C167143
  1. Remove the 3 bolts, nut, and the front lower suspension arm from the front frame assembly.

  1. Remove the front lower arm bushing stopper from the front lower suspension arm.