FRONT LOWER BALL JOINT > INSTALLATION |
| 1. INSTALL FRONT LOWER BALL JOINT |
![]() |
Install the front lower ball joint to the steering knuckle with the nut.
Install a new cotter pin.
| 2. INSTALL FRONT AXLE ASSEMBLY |
![]() |
Install the front axle assembly to the front shock absorber with the 2 bolts and 2 nuts.
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
| 4. INSTALL FRONT LOWER SUSPENSION ARM |
![]() |
Install the front lower suspension arm to the front lower ball joint with the bolt and 2 nuts.
| 5. CONNECT TIE ROD ASSEMBLY |
Connect the tie rod assembly LH to the steering knuckle with the nut.
Install a new cotter pin.
| 6. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the front disc.
| 7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.
| 8. INSTALL FRONT SPEED SENSOR |
![]() |
Install the clamp and front speed sensor with the bolt.
| 9. INSTALL FRONT AXLE HUB NUT |
Clean the threaded parts on the drive shaft and axle hub nut using a non-residue solvent.
Using a socket wrench (30 mm), install a new axle hub nut.
| 10. CHECK ABS SPEED SENSOR SIGNAL |
| 11. INSTALL FRONT WHEEL |
| 12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |