Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Remove the engine assembly with transaxle (Click here).



2. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH


    C167139
  1. Remove the nut and separate the front stabilizer link assembly LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.



3. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



4. REMOVE NO. 1 FRONT STABILIZER BRACKET LH


    C167140
  1. Remove the 2 bolts and the No. 1 front stabilizer bracket LH from the front frame assembly.



5. REMOVE NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



6. REMOVE FRONT STABILIZER BAR


7. REMOVE NO. 2 FRONT STABILIZER BRACKET LH


    C167141
  1. Remove the No. 2 front stabilizer bracket LH from the front stabilizer bar bushing.



8. REMOVE NO. 2 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



9. REMOVE NO. 1 FRONT STABILIZER BAR BUSHING
  1. Remove the 2 No. 1 front stabilizer bar bushings from the front stabilizer bar.